Pulser Sequencer Kit For Miller 250 DX Syncrowave Tig Welder PN 300547 & 300548

Description: This is new Production Aftermarket Replacement Pulse Board For Miller Part # 300548 (Pulser) & 1300547 (Sequencer) Only. Replaces Miller Part #'s Miller Part # 300548 (Pulser) & 300547 (Sequencer) Only. See Photos Make Sure Your Machine Matches. SN: LE282983 And Later For 250DX Models SN: LE223624 And Later For 350LX Models This will NOT REPLACE Miller Part # 190734 or 190738 (See Other Listings) Please Verify Your Serial Number and Part Number to the Miller Owners / Parts Manual Prior to Buying. Any Compatibility Questions Message me a machine photo and serial Number I will check for you. You can find your manual for your welder at https://www.millerwelds.com/support/manuals-and-parts This is V2.0 Retail Board, Limited to Stock On Hand (Compare to Genuine Miller at $1155.00 For the Set) Will Come with What you see in the Photos assembled board and cables. These are Hand Assembled In the USA, I will try and keep assembled stock on Hand but Please Allow 2-3 Days For Shipment. Please Note: This is For the Newer Miler Syncrowave 250DX Units That Have a Slanted Face. If you have an older 250DX (Flat Face) unit this will not fit (See Photos). You can message me a photo of your machine to verify before ordering if you have any doubts. Buyer Agrees No Refunds No Returns After 14 Days. All Returns Buyer Pays Return Shipping. This Requires You To Open Up Your Miller 250DX to Install. If you are not comfortable with opening your unit hire a Qualified Professional! Install is Relativity Straight Forward, Ensure Welder Is Disconnected from AC Power!! Disconnect the welder from the AC power source before proceeding with any maintenance or modifications. Remove Welders Cover: Carefully take off the cover from the welder to gain access to internal components. Release Front Panel Caps: Push out the caps that obstruct the holes on the front panel, leaving the small cap in place. Mount the Push Button: Securely install the button in the front panel do not remove o-ring from button. Mount the Pulse and Sequencer Board: Securely install the board and mount using the provided 8 washers and nuts and connect the 4 pin Button Cable to Pulse Board. Connect Cables: Connect the 10-pin cable (Pulse Board) and 14 pin cable (Sequencer Board) to the Main Control board. There are 2 Version of main Boards, See Images: #3 Is Pulser and #4 is Sequencer On Both. Install and Set Knobs: Rotate the potentiometer fully clockwise (Right) Position knob so the the pointer aligns with the 100/10/95 & 15/5/25/100/100 lines press knobs to set it rotate knob back counter clock wise (Left). Test and Reassemble Machine.

Price: 664.99 USD

Location: Vancouver, Washington

End Time: 2024-08-25T00:12:58.000Z

Shipping Cost: N/A USD