Description: This holds 2 Tape Measures at a slight 10-degree angle and mounts on Gladiator Gearwall or GearTrack. It is designed to work with many 25' tape measures, including wide versions (such as Stanley FatMax). For each tape measure, the maximum width is 1.9" (49mm) but they also has a notched slot to hold tape measures that are 1.5" (39mm) wide as well. For reference, see photos for a variety of tape measures it can hold. Smaller or skinnier tape measures may not be held well. The sides are mostly open and there's a wide gap between the 2 locations to allow for belt clips to not interfere. The back is shipped separated from the base and is attached via included screw and nut. You will need a screwdriver for simple assembly. No Tape Measures are included. Tape Measures shown in photos are for reference purposes only. Holder Dimensions: 4.7" x 4.3" x 4" (118mm x 108mm x 102mm) These are uniquely designed and 3D-printed by the Seller in the USA. There is no warranty and are sold as-is. Items are lightweight and made of PLA plastic thus we cannot warrant that deformations or failure may occur due to extreme temperatures, stress, or weight. Due to the printing process, there may be some minor imperfections which are mostly likely to be on the bottom/back side, not exposed to view. 3D Printing involves the heating and depositing of material on a flat board one layer at a time, thus most exposed sides have small, fine lines. Infill (non-exposed) areas are not solid plastic. Please see our other items for sale and look up the full line in our etsy shop under acmcstudios. We have several other designs available.
Price: 9.95 USD
Location: Lexington, Kentucky
End Time: 2024-12-02T22:39:26.000Z
Shipping Cost: N/A USD
Product Images
Item Specifics
All returns accepted: ReturnsNotAccepted
Brand: Unbranded
Material: Plastic
